| Super Pétrel | |
|---|---|
| Lithuanian registered Super Pétrel | |
| Role | Two seat amphibian |
| National origin | Brazil |
| Manufacturer | EDRA Pecas e Manutencao Ltda |
| Designer | Traceable through developments to Claude Tisserand. |
| Introduction | 2002 |
| Status | in production |
| Number built | 214 by December 2009; further 160 kits by end 2007. |
| Unit cost | 2008 prices for Super Pétrel in US$: 28,980 kit 68,000 flyaway |
| Developed from | EDRA Aeronautica Paturi |
The EDRA Aeronautica Super Pétrel is an amphibious pusher configuration biplane, seating two side-by-side, brought into production in Brazil in 2002 though with a French parentage. It remained in production in 2010, in kit and flyaway forms.
Contents |
The design of the Super Pétrel has its origins in Claude Tisserand's Hydroplum, a single seat, wooden amphibian intended for kit building first flown in 1983 and its two seat, Rotax 532 powered development, the 1986 Hydroplum II. The Société Morbihannaise d'Aéro Navigation (SMAN) acquired production rights to the latter in 1987, marketing it as the Pétrel, and passed them on to Billie Marine when SMAN ceased trading. Rights were also bought outside of France; EDRA began Pétrel production in Brazil in 1989. In 1991 they began producing the improved Paturi, which replaced the Pétrel entirely in 1996 but was itself replaced by the Super Pétrel in 2001.[1][2]
The Super Pétrel is of mixed construction though with much use of composite materials. The wings have tubular aluminium alloys spars combined with PVC foam ribs. The leading edges and wingtips are formed from glass fibre composite, with fabric covering elsewhere. The wings have constant chord with angled winglet tips; the upper wing has the greater span, less dihedral (2° 13′ compared with 3° 26′) and greater sweep (4° compared with 2°). There is slight stagger. The Super Pétrel is a single bay biplane with N-form aluminium interplane struts with an additional diagonal strut in each bay from the lower fuselage to the top of the interplane struts. The centre section is supported by a pylon or cabane which also contains the engine mounting. Ailerons are carried only by the upper wings; there are no flaps. The wing scan be disassembled in about 30 minutes for transportation by trailer.[1]
The single step hull is an epoxy/carbon fibre foam monocoque, with a carbon fibre boom supporting the all-composite, cruciform and wire braced tail unit. The rear control surfaces are balanced. The cockpit is forward of the central pylon and seats two side-by-side with dual controls. It may be flown open, with just a windscreen, or enclosed by the single piece, forward hinged canopy. There is a baggage compartment behind the seating. The Super Pétrel has a short legged tricycle undercarriage for land operation; the main units, which have hydraulic brakes, retract upwards through 90° into the sides of the hull with the wheels exposed but recessed into the underside of the lower wing. The steerable nosewheel retracts forward, leaving the tyre partly exposed as a docking fender. A pair of small, stepped floats on the lower wings below the interplane struts stabilize the aircraft on water.[1]
The Super Pétrel is powered by a 73.5 kW (98.6 hp) Rotax 912ULS flat four engine mounted in pusher configuration on the central pylon just below the upper wing. It drives a three blade Airplast propeller, either a fixed pitch model 175 or an electrically controlled, variable pitch model PV 50.[1]
Seven Super Pétrels appeared on the civil aircraft registers of European countries, excluding Russia in mid-2010.[3] There have also been sales in North America, Africa, Australia and New Zealand[1] as well as in Brazil where there were 50 registered by December 2009.[4]
Data from Jane's All the World's Aircraft 2010/11[1]
General characteristics
Performance
|
||||||||||||||
